MK60FN1M0VLQ12

The MK60FN1M0VLQ12 is a 32-bit Kinetis K6x Microcontroller with Ethernet crypto, based on ARM Cortex-M4 RISC architecture core operates at a maximum frequency of 120MHz. The device incorporates 1024kB internal flash, 128kB internal RAM, four 16-bit SAR A/D converter, two 12-bit D/A converter and 100 general-purpose I/O pins. This device also features communication interfaces like six UART modules, three SPI modules, two I2C modules and two I2S modules.

• ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
• Serial programming interface (EzPort)
• FlexBus external bus interface
• NAND Flash controller interface
• 3 to 32MHz and 32kHz Crystal oscillator
• Multi-purpose clock generator
• Multiple low-power modes to provide power optimization based on application requirements
• Memory protection unit with multi-master protection
• 32-channel DMA controller, supporting up to 128 request sources
• External watchdog monitor and software watchdog
• Low-leakage wakeup unit
• Hardware CRC module to support fast cyclic redundancy checks
• Hardware random-number generator
• Hardware encryption supporting DES, 3DES, AES, MD5, SHA-1 and SHA-256 algorithms
• 128-bit Unique identification (ID) number per chip
• Low-power hardware touch sensor interface (TSI)
• Programmable gain amplifier (PGA) (up to x64) integrated into each ADC
• Four analog comparators (CMP) containing a 6-bit DAC and programmable reference input
• Programmable delay block
• Two 8-channel Motor control/general purpose/PWM timers
• Periodic interrupt, 16-bit low-power and IEEE 1588 timers
• Ethernet controller with MII and RMII interface to external PHY and hardware IEEE 1588 capability
• USB High-/full-/low-speed on-the-go controller with ULPI interface
• USB Full-/low-speed On-the-Go controller with on-chip transceiver
• Two controller area network (CAN) modules

Alkalmazások

Industrial, Communications & Networking