ST-LINK/V2-ISOL

ST-LINK/V2-ISOL is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to provides the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000Vrms. STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD) or ST Visual Program (STVP) software. STM32 applications use the USB full-speed interface to communicate with Atollic®, IAR™, Keil® or TASKING integrated development environments.

• 5V power supplied by a USB connector, USB 2.0 full-speed-compatible interface
• 1.65V to 5.5V application voltage supported on SWIM interface
• SWIM low-speed and high-speed modes supported
• SWIM programming speed rate: 9.7Kbytes/s in low speed and 12.8Kbytes/s in high speed
• SWIM cable for connection to the application via a pin header or a 2.54mm pitch connector
• 1.65V to 3.6V application voltage supported on the JTAG/SWD interface and 5V tolerant inputs
• JTAG cable for connection to a standard JTAG 20-pin pitch 2.54mm connector, JTAG supported
• Direct firmware update feature supported (DFU), status LED which blinks during communication with PC
• Operating temperature range from 0 to 50°C
• 1000Vrms high isolation voltage

Tartalom

ST-LINK/V2 in-circuit debugger/programmer, USB standard A to mini-B cable, SWIM cable w/ ERNI conn.